If you replace the existing bib taps with the most modern design, is a relatively simple matter to disconnect and screw the new and old faucets fitted to their place. But it is very likely to completely remove the bib taps and faucets installed a new sink with some pillars. It contains a plumber bit 'more.
To begin, you need water from taps and remove the old sink. If youpipes from the floor for the sector by far in the wall under the sink when new. You will be able to remove the tubes from the wall easily and cut sections visible. This will allow short length of new pipe, slightly bent, if necessary, connecting pipes to connect the ends and tap the tail. Alternatively, if the pipes from the wall, you must extend to the area below the sink again and elbows used to connect pipes to the taptails. In both cases it is a good idea to mount the sink taps in the foreground and the new duct work running a bit 'too long, that when the sink is sacrificed to the new wall that can be measured accurately and avoid the risk of cutting the long tube. Rather than dealing with difficult turns, you can use lengths of copper tubing, corrugated to do. One side of the tube is clear so it may be that the pipes 15 mm with a compression fitting or welding or capillary, theOn the other hand, a valve plug travel.
0